Firmware Version
Initial Configuration
Router Access
Router internal ip: 192.168.210.1 (default ip, hidden & only accessible from LAN side)
Use Eth2 (LAN) to access
PC with ip address dhcp connect to Eth2 (ip address pool might difference but above hidden ip always accessible)
Default Credentials:
username: admin
password: label in the back of the unit
Enable WEB/SSH access thru Cell interface
Web Access
System Configuration >> Device Configuration >> Services >> Web administration >> Access control list >> Zone: add External zone
2. ssh access
System Configuration >> Device Configuration >> Services >> SSH >> Access control list >> Zone: add External zone
Enable shell access (linux shell)
System Configuration >> Device Configuration >> Authentication >> Groups >> admin >> Interactive shell access: enable
System Configuration
Superneting Configuration
Note: Ensure the core router has config route setup to this subnet via network domain interface ip and supernetting is enabled on Celona Orchestrator
Static ip address on LAN interface (gateway for UE connected to this port)
System Configuration >> Device Configuration >> Network >> Interfaces >> ETH2 >> IPv4: set static ip address
2. Disable DHCP server
System Configuration >> Device Configuration >> Network >> Interfaces >> ETH2 >> IPv4 >> DHCP server: disable
3. Enable DHCP Relay
System Configuration >> Device Configuration >> Network >> Interfaces >> ETH2 >> IPv4 >> DHCP server: click on + button to add ip address of dhcp server that Digi will relay bootps packet over
4. Disable SNAT on External Zone
System Configuration >> Device Configuration >> Firewall >> Zones >> External: disable SNAT
