Skip to main content

Sierra Wireless Airlink RV55

Recommended Configuration for Sierra RV55 on Celona Networks

Team Celona avatar
Written by Team Celona
Updated over 3 weeks ago

Firmware version

Initial Configuration


Router Access

Router internal ip: 192.168.13.31

Default Credentials:

username: user

password: label in the back of the unit

System configuration

Config for passthrough

Navigate to LAN >> DHCP/Addressing

In IP Passthrough section, enable Ethernet


In Passthrough Mode: select First Host

click Apply to save config

click OK to on the pop-up to consent device need to reboot to apply new config

click Reboot button to reboot the unit

verify the ip address of the laptop behind this CPE obtain ip address from dhcp server in the backend

Config for Supernetting

  • Disable IP Passthrough

  • Ensure there is a route to this subnet on RV55 LAN interface from the router in the backend via Celona network domain interface ip and

  • enable Supernetting on Celona Orchestrator

navigate to LAN >> Ethernet:

  • change ip address to match with the one for supnerneting in Device IP section

  • set DHCP Mode to Relay

  • DHCP Relay Server set to dhcp server ip in the backend

turn off NAT on Cell interface: navigate to WAN/Cellular >> General >> Advanced >> Turn Off NAT: set to Enable

click OK to on the pop-up to consent device need to reboot to apply new config

click Reboot button to reboot the unit

Verify ip address of the laptop behind this CPE is getting ip address in subnet that defined for superneting (default ip of the laptop will be RV55 LAN IP config above)

Did this answer your question?