Firmware Version
Initial Configuration
Router Access
Router internal ip: 192.168.1.1
Use ethernet port 2 or 3 on main board or ethernet on Cartridge
DHCP server running by default, PC directly connected to this LAN port will have 192.168.1.x/24
Default Credentials:
username: admin
password: <on the label in the back of the unit>
System Configuration
Enable IP Passthrough on main board:
Networking >> General >> WAN Services
In WAN Services >> WAN SERVICES TABLE, select Cellular (for main board) and scroll to the right look for the 3 dots then edit
Modify config to be passthrough as below. once config done, click “Update“ to save new config
then “save“ to apply
connect the laptop to Ethernet 2 in the back of the router to see ip address get change from default 192.168.1.x to the desired network in passthrough mode
Enable IP Passthrough on Cartridge board
IP passthrough can only work with either main board or Catridge card but not both at the same time. Apply the configuration for the main board but select the XP Cellular and XP Ethernet instead.
below is the issue that only 1 IP_PassThrough: profile available at the time
