Firmware Version
Initial Configuration
Router Access
Router internal ip: 192.168.0.1
Use ethernet port 2
DHCP server running by default, PC directly connected to this LAN port will have 192.168.0.x/24
Default Credentials:
username: admin
password: <on the label in the back of the unit>
Setup wizard (first time open unit from shipping image)
Select WAN Connection: Wireless (Cellular)
Select the SIM slot that intended to use for CBRS and edit the following:
Maximize bandwidth
Configure APN: celonadns
System Configuration
Enable IP Passthrough on main board:
Networking >> General >> WAN Services
In WAN Services >> WAN SERVICES TABLE, select Cellular (for main board) and scroll to the right look for the 3 dots then edit
Modify config to be passthrough as below. once config done, click “Update“ to save new config
then “Save“ to apply
connect the laptop to Ethernet 2 in the back of the router to see ip address get change from default 192.168.1.x to the desired network in passthrough mode
Enable IP Passthrough on Cartridge board
Currently ip passthrough can only work with either main board or Catridge card but not both at the same time
same configuration for the main board but select the XP Cellular and XP Ethernet instead.
An open issue is that that only 1 IP_PassThrough: profile available at the time.