This article describes the IP interface and address requirements for Celona Edge clusters running EdgeOS 2026.1. With HA 2.0, Edge clusters operate in an active-active model and are supported in single-node, 2-node, and 3-node configurations.
Note: EdgeOS 2026.1 (Phase 1) supports 5G only. Interface references in this article use 5G naming (N2, N3, N6).
Single Node Cluster
Base single node cluster IP requirement | Qty. | Description |
AP to Edge control plane on native VLAN (S1-MME, N2-AMF) | 1 | One IP address for each Edge node |
AP to Edge data plane on native VLAN (S1-U, N3) | 1 | One IP address for each Edge node |
For every External Domain | Qty. | Description |
Edge to Enterprise LAN data plane on tagged VLANs (N6/UPF) |
0 1 | If Layer 2 External Domain, no N6 IP interface If Layer 3 External Domain; one IP address for each Edge node |
2-Node Cluster (HA 2.0)
Base 3-node cluster IP requirements | Qty. | Description |
AP to Edge control plane on native VLAN (S1-MME, N2-AMF) | 2 | One IP address for each Edge node |
AP to Edge data plane on native VLAN (S1-U, N3) | 2 | One IP address for each Edge node |
For every External Domain | Qty. | Description |
Edge to Enterprise LAN data plane on tagged VLANs (N6/UPF) | 0
2
1 | If Layer 2 External Domain, no N6 IP interface If Layer 3 External Domain; one IP address for each Edge node If Layer 3 External Domain; one VRRP IP address for Edge Cluster |
3-Node Cluster (HA 2.0)
Base 3-node cluster IP requirements | Qty. | Description |
AP to Edge control plane on native VLAN (S1-MME, N2-AMF) | 3
| One IP address for each Edge node |
AP to Edge data plane on native VLAN (S1-U, N3) | 3 | One IP address for each Edge node |
For every External Domain | Qty. | Description |
Edge to Enterprise LAN data plane on tagged VLANs (N6/UPF) | 0
3
1 | If Layer 2 External Domain, no N6 IP interface If Layer 3 External Domain; one IP address for each Edge node If Layer 3 External Domain; one VRRP IP address for Edge Cluster |
Note
All IP addresses are allocated by default using DHCP
Refer to the Edge Cluster creation workflow to allocate static IP addresses
Static N2 (control plane) addressing, including per-node subnet mask, gateway, DNS, and NTP servers, is set in the Local Edge Manager UI
Static N3 (data plane) addressing is set in the Orchestrator UI on the Edge Cluster details page
Static N6 addressing, including the VRRP IP address and VRRP ID for Layer 3 External Domains, is set in the Orchestrator UI during External IP Domain creation
If using DHCP, it is highly recommended that IP addresses are reserved for all interfaces
Interface MAC addresses can be found in the Orchestrator for reference
Use the Celona Edge Cluster IP Network planning sheet to assist with IP design: